![]() The mains filter may be in the way, so loosen the two allen screws so it can be moved clear if required. Make a drawing of the wiring from the pressure switch to the element, and then disconnect the wiring and the pipework at the boiler end and lift the pressure switch clear. Mine was blocked, so I recommend taking a bolt out of the end plate (behind the copper tube in photo below) and siphoning out any remaining water (later edit: it has a blanking plug over the tap outlet – only remove when the boiler is cold). The boiler can be drained using the tap under the drip tray. This is also a great time to have a look inside. ![]() I bought a Bezerra Ellisse with a fault described as “lots of steam escaping”, so the first task was to take the end cover off the boiler and replace the gasket.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |